Wondering about changing parameters when the engine is running. Can this be done? As in pick the cells in the VE table that are rich/lean and change add or sub fuel while the engine is running to see if you make a change.

Also what is the deal with TOG scaling? I was looking at this a bit last nite. Meaning we have a 3 bar sensor in the turbo vw and by scaling TOG to a lower boost level we are adding fuel/injector time?

It absolutely can. Highlight the portion you want to modify, and you can either type in a new value that will be applied to all of the highlighted cells or you can use the '<' and '>' keys to decrease or increase the valuse in the highlighted cells. This will all happen in real time so you will see the effect immediately.

TOG defines the pulsewidth you would get at 5v from the MAP sensor. If you're not using the whole range of the MAP sensor, the horsepower you xpect to make is not made at 5v. It's made at some lower voltage. So to get the pulsewisth you need at that lower voltage, you need to put a much higher pulsewidth into TOG.

Hope this helps.